SPS/FA-66 is Not Listed

Last updated on 3/22/2016

The information in this article applies to:

  • SONAR REAC Recording System

If an audio device does not appear in the REAC Panel Output Monitor ASIO Device list, ensure that the SPS/FA-66 is connected, powered on and is set to the correct sample rate. If the sample rate on the SPS/FA-66 needs to be changed, follow the steps below:

  1. Close SONAR
  2. Turn the SPS/FA-66 off. You do not need to disconnect it from the PC.
  3. Change the sample rate on the SPS/FA-66.
  4. Turn the SPS/FA-66 on.
  5. Start SONAR
  6. Open a project

    You do not need to restart your computer in order for
    this change to take effect.

 

Cakewalk // Support // Knowledge Base // SPS/FA-66 is Not Listed
Copyright © 2017 Cakewalk, Inc. All rights reserved
Sitemap | Privacy Policy | Legal