Cakewalk provides several commands to boost or cut the volume of audio data. The Process > Apply Effect > Normalize command, and the Process > Apply Effect > Gain commands are used to control the volume of selected audio data, in decibels. For more information about the decibel scale, see The decibel scale. The Normalize command “normalizes” the audio data: it boosts the volume until the maximum amplitude is reached somewhere in the data. By normalizing the data, you achieve the maximum possible volume without distortion or clipping. The Gain command lets you edit the volume, phase, and stereo interleave of selected audio data. You can also use this command to remove center material from a clip (good for removing vocals).Like all the audio processing commands, these commands work by modifying the waveform data. You can achieve volume changes non-destructively using automation. For more information, see Automation.
Normalize raises the noise floor; that is, while it increases the volume of the signal, it also boosts the noise it contains. (This is true when you raise the volume by other means, too.)
If the selection contains any loud signals, Normalize may not seem to have any effect. This is because the volume increase is determined by the loudest audio in the selection. If an audio clip contains segments that are too quiet and others that are loud, you should probably split off the quiet segments into separate clips and then normalize those.
2. Choose Process > Apply Effect > Normalize from the menu.The Normalize dialog box appears.
3. Drag the Normalize Level slider to the approximate level you think is appropriate.
4. Click OK to process the selected audio.Listen to the edited data. You can use the Edit > Undo command if you don’t like the results, and then try a different setting in the Normalize dialog box.
2. Choose Process > Apply Effect > Gain to open the Gain dialog box.
3. If you only want to change the overall volume of the selection, move the New Left Channel-From Left slider and the New Right Channel-From Right sliders by a similar amount. You can press the Audition button to try out your edits.
5. If you want to invert the left channel phase, click the Invert left-channel phase button . If you want to invert the right-channel phase, click the Invert right-channel phase button in the New Right Channel section.
6. If you want to remove center material (usually where the vocal track is), set the New Left Channel-From Left slider and the New Right Channel-From Right slider to 100%, and set the New Left Channel-From Right slider and the New Right Channel-From Left slider to -INF.
7. Press the Audition button if you want to audition your edits.
8. Click OK to process the selected audio.Listen to the edited data in your mix. You can use the Edit > Undo command if you don’t like the results, and then try different settings in the Gain dialog box.
Tip - Searching Documentation
Tip: To search for a specific topic, type your search query in the Search Cakewalk.com field at the top right of this page.
When the search results appear, click which product's documentation you would like to search to filter the search results further.
Note - Using Offline Help
Note: If you prefer to always use offline Help, go to Edit > Preferences > File > Advanced in your Cakewalk software and select Always Use Offline Help.
If you are not connected to the internet, your Cakewalk software will default to showing offline help until an internet connection becomes available.