The Time ruler appears in the Track view, Tempo view, Staff view and Piano Roll view. It has several functions, including:
Making a time selection. The Time ruler follows the Snap to Grid settings, if enabled.
Adding loop, punch, and pitch markers. You can right-click in the Time ruler to add markers.
In the Track view and Piano Roll view, the Time ruler has the following time display options or formats:Figure 3477. The Time ruler.A. M:B:T B. H:M:S:F C. Samples D. Milliseconds E. Remove ruler F. Add rulerThe M:B:T setting follows your settings in the Meter/Key view. If you project is set to 4/4 time, you have four beats in the Time ruler for each measure. If your project is set to 6/8 time, you have six beats in the Time ruler for each measure.
Note: When Smart Grid is enabled in the Control Bar’s Snap module, the M:B:T Time Rulers in the Clips pane and Piano Roll view are optimized to show relevant snap locations.If there is only one format displayed in the Time ruler, you can switch the format by right-clicking in the Time ruler and selecting the format you prefer.
2. In the menu that appears, select Time Ruler Format > M:B:T.
2. In the menu that appears, select Time Ruler Format > H:M:S:F.
2. In the menu that appears, select Time Ruler Format > Samples.
2. In the menu that appears, select Time Ruler Format > Milliseconds.Additionally, you can add or remove Time ruler formats using the Plus/Minus buttons located just outside the right edge of the Time ruler.
Note: If only one Time ruler format is being used, only the Plus button is displayed.
Click the Plus button and select a Time ruler format from the pop-up menu.
Click the Plus button and select a Time ruler format you would like to add from the pop-up menu.
Click the Minus button and select from the pop-up menu to remove an active Time ruler format.
Note: Selecting the Display All Times as SMPTE check box in Edit > Preferences > Customization - Display forces all times in the project to be displayed in SMPTE time, regardless of your setting in the Time ruler.
Tip - Searching Documentation
Tip: To search for a specific topic, type your search query in the Search Cakewalk.com field at the top right of this page.
When the search results appear, click which product's documentation you would like to search to filter the search results further.
Note - Using Offline Help
Note: If you prefer to always use offline Help, go to Edit > Preferences > File > Advanced in your Cakewalk software and select Always Use Offline Help.
If you are not connected to the internet, your Cakewalk software will default to showing offline help until an internet connection becomes available.