Cakewalk // Documentation // SONAR X2 // Edit tool
Table of Contents Previous Next Index

Tools ► Edit tool

Edit tool
The Edit tool lets you adjust data. You can slip-edit (trim/crop) clips, adjust note start/end times, adjust fades, and raise/lower note velocity and automation envelopes.
Note: The Edit tool does not work on AudioSnap transients.
Do one of the following:
list-image
Click the Edit tool button in the Control Bar.
Note: The F8 shortcut key cycles through all Edit tools (Edit/Timing/Split). If another Edit tool is selected, press F8 again until the Edit tool is selected.
Using the Edit tool on audio clips
Figure 121. Edit tool hotspots on audio clip.
Table 83. Using the Edit tool on audio clips 
Note: If the clip contains a fade in, drag the top 75% to crop clip start and move the fade in, or or drag the bottom 25% to only crop the clip without moving the fade in.
Note: If the clip contains a fade out, drag the top 75% to crop clip end and move the fade out, or or drag the bottom 25% to only crop the clip without moving the fade out.
Using the Edit tool on MIDI clips
Figure 122. Edit tool hotspots on MIDI clip.
Table 84. Using the Edit tool on MIDI clips 
Note: If the clip contains a fade in, drag the top 75% to crop clip start and move the fade in, or or drag the bottom 25% to only crop the clip without moving the fade in.
Note: If the clip contains a fade out, drag the top 75% to crop clip end and move the fade out, or or drag the bottom 25% to only crop the clip without moving the fade out.
Using the Edit tool on PRV notes
Figure 123. Edit tool hotspots on PRV notes.
Table 85. Using the Edit tool on PRV notes 
Using the Edit tool on automation
Figure 124. Edit tool hotspots on automation.
Table 86. Using the Edit tool on automation 
Drag up/down to adjust selected nodes
Drag up/down to cycle through the line’s available curve types (Fast, Current, Slow, Jump).

Copyright © 2020 Cakewalk, Inc. All rights reserved
Sitemap | Privacy Policy | Legal