SONAR Hangs on Deleting Control Surface While TranzPort is Connected

Last updated on 3/31/2016

SONAR Hangs on Deleting Control Surface While TranzPort is Connected

The information in this article applies to:

  • SONAR 8
  • SONAR 7
  • SONAR 6
  • SONAR 5
  • SONAR Power Studio
  • SONAR 4
  • SONAR Home Studio

Occasionally, more than one instance of the Tranzport will appear in the Control Surface dialog.  Unfortunately, SONAR hangs if you try to delete one while the device is connected. 

To remove the duplicates, close SONAR, unplug the Tranzport, re-open SONAR, go to Options-Controllers/Surfaces, and delete all but one instance of Tranzport. 

At this point you must close SONAR, re-connect the Tranzport and launch SONAR again in order for the Frontier MIDI drivers to become available so the surface will work.

Cakewalk // Support // Knowledge Base // SONAR Hangs on Deleting Control Surface While TranzPort is Connected
Copyright © 2017 Cakewalk, Inc. All rights reserved
Sitemap | Privacy Policy | Legal